Skip to main content

Privacy

Privacy Policy

This is a public Blog. That implies that any response you might wish to give to any of the published articles, is public as well, and can be read by onyone. Please consider this when determining the content of your response, especially where privacy sensitive information is concerned.
If you wish to contact me directly, you can use the contact form in the menu on the top-right of this blog. That will create a mail to me directly, without other visitors being able to see what you post. You will need to provide a valid email address for the contact form to work properly, though.
I will never use this site to collect personal data (like email addresses), nor will I ever actively provide such information to third parties.
The Google Adsense application on this site does use cookies and/or webbeacons, however, in order to be able to determine which links could be of interest to you. Please not that, if you so wish, you can disable cookies in your browser's security settings.

Comments

Popular posts from this blog

Tevo Tarantula prints

I am very happy with my Tevo Tarantula 3D printer! I have it up and running for about 6 weeks now. Let me tell you about my prints so far! Reading all the forums, facebook groups, and of course the Tevo website, I decided on the way forward after finishing the build. First, I would need to be able to print dimensionally reasonably accurate parts. In order to achieve that, I fist took a  look at the extrusion. It is important that the extruder extrudes the commanded length of filament, to within a few percent. To check that, I fed in the filament for only a few centimeters. With that as "0", I measured 120mm from the infeed side of the extruder, and marked the filament with a black marker. Then, I commanded the extruder to feed 100mm into the teflon tube, and mesured how far from the extruder infeed side the mark ended up. That should be 20mm, of course, but in my case it was less than that. So I had to tune down my extruder a bit. As I measured 17mm, it had "over-

Binding FrSky S8R stabilizing receiver

What could be easier than binding a receiver to a transmitter, right? Push the bind button while powering up the receiver, put the transmitter in binding mode, wait a few seconds, done! Well ... With the FrSky S8R receiver, there are a few "other possibilities"...

ZOHD Talon GT with Matek F405 WING, GPS, BlueTooth, FPV, Long Range - Part 1

This is going to be a small series of me assembling a ZOHD Talon GT in an INAV configuration. I have the Talon on order already, and am waiting for it to arrive. Banggood was kind enough to supply me with a MATEK F405 WING flightcontroller, a Ublox M8N GPS , and an FrSky XM+ receiver to test this configuration 😁 The Talon was paid for regularly, mind you. Just to be clear and transparent on that. This makes an INAV configuration possible, but the most obvious next step would be to introduce a long-range transmitter module / receiver combo. The XM+ shoud have a decent enough range to fly line of sight, and maybe some FPV, a little further out, but an FrSky R9M setup (ca. €100), or even better: a Crossfire setup  (ca. €200), would be the way to go for this type of flying. I don't have those yet, so donations are always welcome! That can be as simple as clicking on any of the (affiliate product links in this blog, and ordering something from those stores that are linked. It do